Engine not specified
157480 mi C $120 |
Replace lower right ball joint, car was sold and this was the only problem found in the safety check. |
141600 mi US $250 |
Front passenger corner needed to replace a ball joint. |
4-cylinder manual 2WD
170000 mi US $1400 |
Rear bushings needed to be replaced (first time). |
116000 mi US $320 |
Wheel bearing replaced. |
127000 mi US $280 |
Other wheel bearing was going bad, replaced at independent shop. |
170000 mi US $700 |
Replaced control arms on right side. |
4-cylinder automatic 2WD
97300 mi US $800 |
Rear suspension bushings. Alignment problem. |
115700 mi US $592 |
Replaced Ball Joints. Oil Change. Rotated tires |
202000 mi US $50 |
Had to replace Rear Trailing Arm Bushings. This is a first for this car. And I have had since new! |
213300 mi US $500 |
Replaced shocks/struts on all 4 wheels. |
155000 mi US $900 |
Replaced fluid reservoir and hoses. |
111600 mi C $1250 |
Both control arms replaced. |
190000 mi US $40 |
Replaced left lower ball joint. |
4-cylinder manual 2WD
176120 mi C $110 |
Driver's side upper control arm replaced due to bad balljoint |
150660 mi C $350 |
The suspension was noisy and over bumps there was a tug on the steering wheel. A ball joint needed replacing, and the mechanic said it was a safety issue. |
61380 mi C $632 |
Replace front suspension components. Bushings had free play, so replaced lower ball joints and upper control arms that also include ball joints. |
149000 mi | car needed ball joints, rack and pinion (inner tie rods), CEL on (EGR solenoid-rear), needed new brakes all around, a/c broken |
107880 mi C $590 |
Failing wheel bearings in front passenger/rear driver corners |
152000 mi US $326 |
Front right coilover broken at bottom, not safe to drive. Replaced strut assembly and sway bar links. Also fixed vibration at high speeds. Self repair, no labor paid except alignment after replacement. |
4-cylinder manual 2WD
204000 mi US $60 |
Replaced upper ball joint on the drivers side front suspension. |
216900 mi US $450 |
drivers side front bearing was going out. Replaced the bearing at the repair shop I go to. Cost with labor was about $400. Did not have to replace the hub, thank goodness! Vehicle is running good as new again - everything's OK! |