381-horsepower 5.7L V8 6-speed automatic 4WD, part-time w/low range
17000 mi | Brake line was rubbing leaf spring and wore through. Replaced brake line and fixed bracket which was supposed to hold it out of the way. |
248000 mi US $1100 |
Replaced front rotors and brake pads. |
256000 mi US $649 |
Replaced rear ceramic pads, new front tire M & b |
126000 mi US $530 |
Replaced front calipers due to brake pins rusted in place. |
188688 mi US $75 |
While Replacing all four pads and rotors. Found front left caliper was sized up. Replaced that. |
122000 mi US $780 |
Rear brake calipers frozen due to excessive wear. |
14250 mi | Under Warranty replacement of the Traction Control ABS computer Module |
14750 mi | Under Warranty replacement of the Rear Wire Harness to the ABS sensors |
125000 mi | Corrosion in the left wheel speed sensor connector. This is my second water related problem in three months.This truck has almost exclusively highway driving and one truck wash every two weeks. 2007 Tundra is an embarrassment to Toyota. |
30000 mi US $159 |
Corroded wire connected to left front sensor. The wire was tightened and the sensor contacts cleaned. |
30000 mi US $285 |
Speed Sensor failed a week later and had to be replaced. |
271-horsepower 4.7L V8 5-speed automatic RWD
100000 mi US $798 |
Replaced master cylinder |
271-horsepower 4.7L V8 5-speed automatic 4WD, part-time w/low range
109740 mi C $1030 |
New calipers and brake lines to meet inspection requirements for transfer of ownership. |
381-horsepower 5.7L V8 6-speed automatic 4WD, part-time w/low range
149000 mi US $31 |
stop light switch |
90000 mi | Dust shield rubbing on wheel. Repair done for free (bent back in to shape). Shop stated if happens again I'll need a new shield, but the shield is attached to a full assembly costing 1,100. This would be a rip off. |
271-horsepower 4.7L V8 5-speed automatic RWD
17800 mi | Lights came on: VSC flashing, BRAKE steady, LSD steady. Took in for diagnosis: No ABS= Master Pressure Sensor or entire Brake Booster. Scan Tool needs update to nail down fault. Will call me when update loaded and diagnose again. Master Pressure Sensor Failure |