207-horsepower 4.0L V6 5-speed automatic 4WD, part-time w/low range
Mazda B-Series Truck in Ontario, Canada Jun 2017 - Jun 2018 | |||
Nov 201771920 miC $400 | Front driver side wheel bearing replaced |
207-horsepower 4.0L V6 5-speed automatic 4WD, part-time w/low range
Mazda B-Series Truck in Maryland, United States Jun 2013 - Jun 2018 | |||
Jun 201328000 miUS $528 | Rodent ate my gas line. Fuel was leaking. Fuel line(s) replaced. Quite an involved looking fuel line harness. | ||
Dec 201434000 miUS $400 | wheel bearing failed, unable to drive the vehicle, towed to shop | ||
Sep 201660000 miUS $300 | Fuel filler neck broke lose at a weld. Was replaced. | ||
Sep 201746000 miUS $1350 | Replace Ac compressor, recharge, etc Replace all gear oil in all 3 differentials, replace rear end cover |
154-horsepower 3.0L V6 5-speed automatic RWD
Mazda B-Series Truck in Ontario, Canada May 2013 - Sep 2016 | |||
Aug 2013107260 mi | Left ball joint was replaced | ||
Jan 2014C $200 | Truck wouldn't start even though there was power available. Replaced the starter. The Battery was also on its "last legs" so it was also replaced. | ||
Jan 2016108580 miC $250 | Replaced muffler | ||
Jun 2016112840 miC $80 | replaced front link - a very cheap part | ||
Sep 2016112840 miC $30 | blower wouldn't work - needed new resistors |
207-horsepower 4.0L V6 5-speed automatic 4WD, part-time w/low range
Mazda B-Series Truck in Newfoundland / Lab., Canada Jan 2017 - Jul 2018 | |||
Nov 2017102920 miC $200 | Rear u joint replaced Replaced fan clutch | ||
Dec 2017105400 miC $120 | Bearing was roaring |
6-cylinder automatic 2WD
Mazda B-Series Truck in Florida, United States Apr 2012 - Sep 2015 | |||
Sep 201346000 miUS $600 | Had bushings in front end replaced as well as steering rack ball joints. |
143-horsepower 2.3L I4 5-speed manual RWD
Mazda B-Series Truck in Alabama, United States Nov 2016 - Jul 2022 | |||
Apr 2017132000 miUS $30 | Replace Thermostat. Thermostat was stuck in open position. Normal wear and tear repair. | ||
Sep 2017135500 miUS $350 | Pinion Bearing Seal replacement due to age. Original Seal failed due to age Forward Lower Ball Joint, Passenger Side | ||
Mar 2021161000 miUS $1500 | Replaced clutch (Manual transmission), because the transmission had to be pulled out to perform this repair, we opted to replace all of the internals/rebuild the transmission to save having to do it later. |
143-horsepower 2.3L I4 5-speed manual RWD
Mazda B-Series Truck in British Columbia, Canada Jan 2012 - Feb 2012 | |||
Feb 201258900 miC $35 | Windshield wiper switch broke (can't be turned off) note: part purchased from local Ford dealership |
207-horsepower 4.0L V6 5-speed manual 4WD, part-time w/low range
Mazda B-Series Truck in Hawaii, United States Nov 2016 - Dec 2016 | |||
Nov 2016120000 miUS $220 | Overheating, solved with hose and fittings |
207-horsepower 4.0L V6 5-speed automatic 4WD, part-time w/low range
Mazda B-Series Truck in Ohio, United States Jan 2010 - Feb 2015 | |||
Jul 2010122000 miUS $30 | driveshaft u-joints replaced | ||
Sep 2010124000 miUS $20 | Cracked PCV hose setting 171/174 (lean mixture) codes. aped hose temporarily until proper parts can be obtained. | ||
Jan 2011128000 miUS $50 | Thermostat housing is made of plastic. A seam failed and by the time the leak was noticed, it was substantial. The housing is difficult to access and the intake manifold has to be removed to replace it. The housing should have been metal. | ||
Aug 2012128000 miUS $500 | Rear brake lines corroded through, replaced. | ||
Apr 2013129000 miUS $50 | The left front brake line ruptured. Replaced front brake lines and re-filled brake fluid. Check engine light on, codes P0135 and P2195. Replaced oxygen sensor, bank 1, sensor 1. |
207-horsepower 4.0L V6 5-speed automatic RWD
Mazda B-Series Truck in Texas, United States - Nov 2009 | |||
Jan 200434914 mi | Warranty work - Check engine light on. Replaced boost sensor. | ||
Nov 200999800 miUS $80 | Battery dead cell. |
207-horsepower 4.0L V6 5-speed automatic 4WD, part-time w/low range
Mazda B-Series Truck in Alberta, Canada Oct 2013 - Nov 2019 | |||
Aug 2014119000 miC $195 | Hole in the tube to PCV valve which caused my check engine light to come on, | ||
Nov 2015132020 miC $800 | Leaking brake lines on both back brakes ruined brake shoes | ||
Sep 2016138260 miC $195 | Battery was dead. |
135-horsepower 2.3L I4 5-speed manual RWD
Mazda B-Series Truck in Puerto Rico Mar 2015 - Jul 2018 | |||
Jun 2016148000 miUS $95 | Ac hose repair ac charge | ||
Jul 2018176000 miUS $650 | Clutch Master cylinder |
147-horsepower 3.0L V6 5-speed manual RWD
Mazda B-Series Truck in Nevada, United States Jun 2011 - Jun 2018 | |||
May 201291900 miUS $200 | Truck would not start. Determined problem due to no fuel delivery to engine. Fuel pump in the fuel tank failed. Replaced fuel pump which resolved the problem. | ||
Oct 201295000 miUS $140 | Replaced front and rear shock absorbers | ||
Dec 201296000 miUS $25 | Oil pressure gauge acting up when getting off freeway. Replaced oil pressure sending unit with Ford/Motorcraft genuine sender and all is OK. | ||
Sep 2013103000 miUS $20 | Re-shim AC clutch air gap and replaced AC clutch relay. | ||
Dec 2014112000 miUS $75 | Replaced camshaft position sensor Replaced driver side power window regulator motor | ||
Feb 2015115000 miUS $35 | Replaced serpentine belt idler and tensioner pulleys due to noise at cold start up. | ||
Jun 2015116000 miUS $25 | O-ring seals on fuel injector was leaking, replace all 12 injector seals (2 per injector). | ||
Jul 2015116300 miUS $6 | Was getting OBDII code for slight leak in evap system. Found hose in engine compartment between charcoal canister and metal line to be questionable. Replaced hose, cleared code, all OK | ||
Jun 2016122000 miUS $150 | Fuel pump failed in 115 degree Las Vegas heat. Installed replacement, in tank, fuel pump assembly. |
Mazda B-Series Truck in Florida, United States Mar 2014 - Jun 2022 | |||
Jun 2018127000 miUS $400 | upper control arms, ball joints upper and lower. Inner and outer tie rod ends, front and rear shocks, new tires and an alignment | ||
Dec 2021145000 miUS $75 | One Rear wheel cylinders leaking | ||
Mar 2022145000 miUS $1200 | slave cylinder leaked: third time in 145k miles! Changed the clutch while trans was out of car |
207-horsepower 4.0L V6 5-speed manual 4WD, part-time w/low range
Mazda B-Series Truck in New York, United States Jun 2014 - Jun 2022 | |||
Sep 201447000 mi | To eliminate the drive train clunk on extended cab Mazda or Ranger when starting-stopping, disconnect drive shaft at rear end, remove boot clips front slip joint, slide back and pack splines with grease, reassemble, problem solved 1/2 hr job | ||
Sep 201550000 mi | Shop said plug wire were deteriorated because of the age of the truck. I had noticed a drive-ability problem. I replaced them myself, not an easy job! | ||
Jan 201870000 miUS $274 | Noise from front axle, replaced wheel bearing + front caliper |
147-horsepower 3.0L V6 5-speed manual RWD
Mazda B-Series Truck in Nova Scotia, Canada Aug 2011 - Sep 2012 | |||
Oct 2011101060 miC $200 | Noisy hub bearing caused by water infiltration. Bearing replaced. | ||
Sep 2012109740 miC $200 | Block heater frost plug blew out draining engine of coolant. Replaced frost plug, started engine, after 5 minutes CEL came on, white smoke from exhaust. Probable blown head gasket. Truck not worth repairing. |
160-horsepower 4.0L V6 5-speed automatic RWD
Mazda B-Series Truck in Texas, United States Sep 2012 - Jun 2015 | |||
Sep 2013119000 miUS $508 | replace radiator Replace cruise control switch | ||
Apr 2014121200 miUS $600 | power window winder switch failed replace radiator, etc | ||
Jun 2014122000 miUS $200 | door lock switch, driver side |
119-horsepower 2.5L I4 5-speed manual RWD
Mazda B-Series Truck in South Carolina, United States Aug 2014 - Nov 2021 | |||
Oct 2014208300 miUS $146 | Wipers were intermittently inoperable. Replaced the wiper motor. | ||
Feb 2015211100 miUS $2 | Throttle plate was sticking when first applying pressure on accelerator pedal from idle due to carbon build-up. Cleaned throttle body and replaced throttle body gasket. | ||
Jun 2015214000 miUS $600 | EGR valve/tube and DPFE sensor were bad Differential pinion seal was leaking. |
160-horsepower 4.0L V6 5-speed automatic 4WD, part-time w/low range
Mazda B-Series Truck in Colorado, United States Jan 2013 - Feb 2014 | |||
Apr 2013229500 miUS $500 | Lost reverse gear. Forward gears shifting hard. | ||
May 2013231000 miUS $800 | Power Steering Pump, Rack & Pinion, Tie Rod Ends, Ball Joints, Upper Control Arms. Leaf Springs worn. | ||
Aug 2013234300 miUS $800 | Rear Axle Needed Rebuilt |
119-horsepower 2.5L I4 5-speed manual RWD
Mazda B-Series Truck in North Carolina, United States May 2015 - Oct 2021 | |||
Aug 2017146000 miUS $300 | Wheel bearings on front |
Engine not specified
Mazda in Utah, United States Mar 2012 - Sep 2018 | |||
Jun 2012US $1000 | did have to change the GEM module at about 130,000 miles. Truck was stuck in 4 wd low, power windows would not work, and OBD was o/c. Put in a used GEM from a ford explorer and all worked except i could not go over 5 miles and hour. Unplugged the speed sensor wire to the rear diff. , drove to the dealer and asked for a new GEM and reminded them to set the tire size in their computer program for my truck. Three trips later and over $1000.00 they finally got it done...next time i'll just leave the speed sensor unplugged. | ||
Sep 2018180000 miUS $80 | replaced drivers window regulator...power windows.... |
6-cylinder manual 4WD
Mazda in Pennsylvania, United States Aug 2010 - Sep 2012 | |||
Jul 2011122000 miUS $960 | New clutch kit and Slave cylinder installed. | ||
Oct 2011124000 miUS $283 | Universal joint on transfer case connected to front drive shaft broke. Repaired with a repair kit. |
6-cylinder automatic 2WD
Mazda in Ontario, Canada Oct 2012 - Nov 2017 | |||
Dec 2012138260 miC $500 | replaced alternator | ||
Aug 2013144320 miC $650 | fuel injector replaced |
Engine not specified
Mazda in Zimbabwe Jun 2017 - Jun 2018 | |||
Jan 2018177940 mi | bearing adjustment |
4-cylinder automatic 2WD
Mazda in Mississippi, United States - Sep 2017 | |||
Sep 2017118000 miUS $820 | Engine jumped time and bent the valves on #3 Cylinder Shop kept the truck 9 months. AC would not work. It should be noted that this AC system was added by the Mazda dealer and not installed from the factory. Replaced all hoses and recharged system |